Parameter is the actual data required to be collected. They can reference physical areas also known as measurement points or other information required from the field, example cleanness of the area. To create parameter right click on task node in the structure module and select “Add New Parameter”.
...
New parameter modal window pops up outlining main parameter fields:
...
Type (mandatory) Parameter data type (Drop down menu for selection);
Description (mandatory) Name or short description of the parameter (Alphanumeric maximum 512 characters);
...
Vibration data. Example: 1H - motor NDE measurement point. This parameter requires more settings than rest of the parameters. You need to number the position, select direction (horizontal, vertical, axial or other), select processing sets for acceleration, velocity, demodulation and waveform and select limits. Processing sets, Band Alarm Sets and limit sets are defined under “Database Setup” section “Processing Sets”, “Band Alarm Sets” and “Limit Sets” module respectively.
1 – buttons to reset Signal Processing Sets
2 - buttons to reset Band Alarm Sets
2 – Reset Limit sets
Parameter must be saved (created) before defining Failure Frequencies and Defining Analysis Assistant
...